Archive for the ‘saving accounts’ Category

10 Easy Tips To Save Money On Your Home Heating Bills February 19th, 2009

admin

With energy costs higher than they have ever been in recent history, it pays to find ways to reduce your home heating costs. I put together some tips that are easy, cost effective and will all add up to reduce your home heating bills by a significant amount! You don’t need to be Bob Villa either. Some take just a minute or two. Even small changes will add up to big savings over the course of this cold winter!

Here are the 10 tips that I have personally used to save on my home heating costs:

1. Head down to the basement and reduce the setting on your hot water thermostat by about 10 degrees. I wouldn’t go below 120-115 degrees. The adjustment dial is typically a red knob towards the bottom of the water tank.

2. While you are downstairs, make sure you have clean filters for your central air-heating unit. A dirty and clogged filter will force your unit to work much harder and stay on longer as it struggles to fresh air through the clogged filter to heat the rest of your house.

3. Check your air ducts for gaps, leaks or disconnects. If you have any disconnects or leaks in your ductwork, your heating bills could be 25% higher than they need to be if these gaps were sealed. If you can’t do this on your own, hire a professional. This expert can also clean your ducts for added efficiency.

4. Adjust your thermostat a few degrees lower. Believe me, this really adds up. It may not seem like much of a difference to you, but you will notice the difference when you get a lower bill each month!

5. While we are on the subject of thermostats, consider replacing yours if it is not programmable. The reason is, you can set the thermostat so the temperature setting in your house is lower at night than during the day, when you are awake. Also, if you are away at work during the day, you can set it for a lower temperature and have it programmed to start heating the house a little bit before you come home. These aren’t too expensive and are easy to install and configure yourself.

6. Insulate your attic. Heat rises, right? If your attic isn’t properly insulated, all of the heat in your house (and your money) goes right through the roof. Literally! This does require some effort on your part, but following through on this tip will save you a ton of money over the years. Measure the square footage of your attic and buy rolls of insulation, greater than R-13 but no higher than R-30. Wear a mask and gloves when working with insulation because it irritates the skin.

7. Find those leaks and cracks! If you were to add up all of the small cracks and holes in your house, they would probably add up to a small window, wide open, letting cold air in and hot air out. Take the time to find gaps in windows, doors, pipes, electrical and phone lines, your dryer duct and much more. Put weather-strips around your doors and windows. You can buy insulation foam that comes in a can with a straw at the top that allows you to fill in tight spaces. It expands to fill even the smallest cracks. Of all of the tasks, this was the most fun finding and filling these gaps all around the house.

8. Close the vents in rooms that you do not use. I have one room in my house that is not currently in use. I shut the hot air ducts and made sure the windows and doors were properly sealed to limit energy leakage. Why waste your money heating up extra square footage of your house that you don’t even use?

9. Open drapes and shades for all of your windows during the day to let the sun heat your home. In the evening, pull them back down for added insulation. It is amazing how much direct sunlight streaming into your home helps to heat things up.

10. Your fireplace can help and hurt your heating costs. If you are not using your fireplace, make sure the damper is closed. When it is closed, inspect the damper and feel if cold air is still leaking in. If you are using your fireplace, make sure the heating in the rest of your house is reduced or turned off.

Taking the time to implement these tips will drastically reduce your home heating bills. You can get most of them done in just one day, but the payoff will last for as long as you live there! I followed through on each one of these tips and the following winter, my bills were about 25% lower, saving about $100 a month! So roll up your sleeves follow these tips and start saving money on your heating costs!

Continue reading...


 

Private Financing February 14th, 2009

admin

Private financing options are available for personal, investment, and commercial purposes. Private financing simply means you are not dealing with a traditional bank. Private financing can be obtained from private parties who are also known as Angel Investors, hard money lenders, private equity investors, investment groups, or venture capitalists.

Angel investors make up the largest and the most flexible group of private financing options. Angel investors may be relatives, friends, colleagues, or persons as yet unknown to you. If your scope of acquaintances does not yield suitable private financing, spread the word about your project among all of the above, as well as bankers, brokers, business development groups, etc. The right angel investor will for private financing will probably be someone who has some knowledge of your industry. Angel investors may provide a simply loan, repayable with interest and possibly points and a prepayment fee. Alternatively, they may want to take an equity position with your company, taking stock in combination with or instead of interest on the private financing they offer you.

Private equity lenders, aka venture capital firms, can be thought of as a group of Angel Investors providing private financing as a group. Venture capital firms sometimes offer incubators: office suites in which their darling companies (for whom they provide private financing) are housed, watched over, and assisted through the early stages of development. To give private financing groups the returns that their investors are looking for, private equity lenders always want a piece of the action. In exchange for the private financing they offer, private equity lenders take an equity position in your company through stock or some other means and become your financial partner.

Private financing obtained in exchange for stock can be an excellent way to get the initial operating capital needed to start a business, but it can be extremely expensive on the far end. While you will likely not be paying interest in the early stages of your business, you will pay dearly should you become a success.

If you have real estate to collateralize, you may be able to obtain private financing without having to give away an equity position (and a place on your Board, control of your business decisions and all that comes with having a financial partner) by working with a hard money lender. Naturally, hard money lenders can provide financing for real estate investment projects, land acquisitions, and construction projects. But, by collateralizing real estate you already own, you may be able to obtain private financing for purposes completely unrelated to real estate. When it comes to hard money private financing, the use of funds is not as important as a clear indication of how the loan will be paid back. Naturally, if you are unable to repay the loan, the real estate collateralized by this kind of private financing will be sold off by the private financing lender, just as traditional banks foreclose on homes when you cannot pay the mortgage.

Regardless of the path you choose in obtaining private financing, you will find private financing companies are more flexible in lending criteria than banks, SBA, or similar traditional lending institutions. Check out private financing companies and brokers online to see which will suit your business needs most effectively.

Continue reading...